upload
Baldor Electric Company
産業: Electrical equipment
Number of terms: 4774
Number of blossaries: 0
Company Profile:
A protective cover placed on the top of a motor being mounted vertically to protect it from liquids or solids that might drop onto the motor. (It acts similar to an umbrella for the motor.
Industry:Electrical equipment
The rate at which alternating current makes a complete cycle of reversals. It is expressed in cycles per second. In the U.S. 60 cycles (Hz) is the standard while in other countries 50 Hz (cycles) is more common. The frequency of the AC will affect the speed of a motor (see Speed).
Industry:Electrical equipment
A device which, when connected in an alternating-current circuit, causes the current to lead the voltage in time phase. The peak of the current wave is reached ahead of the peak of the voltage wave. This is the result of the successive storage and discharge of electric energy used in 1 phase motors to start or in 3 phase for power factor correction.
Industry:Electrical equipment
The front end of a normal motor is the end opposite the coupling or driving pulley. (NEMA) This is sometimes called the opposite pulley end (O.P.E.) or commutator end (C.E.).
Industry:Electrical equipment
A single-phase induction motor with a main winding arranged for direct connection to the power source, and auxiliary winding connected in series with a capacitor. There are three types of capacitor motors: capacitor start, in which the capacitor phase is in the circuit only during starting, permanent-split capacitor, which has the same capacitor and capacitor phase in the circuit for both starting and running; two-value capacitor motor, in which there are different values of capacitance for starting and running.
Industry:Electrical equipment
The current flowing through the line when the motor is operating at full-load torque and full-load speed with rated frequency and voltage applied to the motor terminals.
Industry:Electrical equipment
The capacitor start single phase motor is basically the same as the split phase start, except that it has a capacitor in series with the starting winding. The addition of the capacitor provides a more ideal phase relation and results in greater starting torque with much less power input. As in the case of the split phase motor, this type can be reversed at rest, but not while running unless special starting and reversing switches are used. When properly equipped for reversing while running, the motor is much more suitable for this service than the split phase start as it provides greater reversing ability at less watts input.
Industry:Electrical equipment
That torque of a motor necessary to produce its rated horsepower at full-load speed, sometimes referred to as running torque.
Industry:Electrical equipment
A centrifugally operated automatic mechanism used in conjunction with split phase and other types of single phase induction motors. Centrifugal cutout switches will open or disconnect the starting winding when the rotor has reached a pre-determined speed, and reconnect it when the motor speed falls below it. Without such a device, the starting winding would be susceptible to rapid overheating and subsequent burnout.
Industry:Electrical equipment
The portion of a gearmotor which contains the actual gearing which converts the basic motor speed to the rated output speed.
Industry:Electrical equipment